Back to Home Page
Site Features

 


VTT 600 Setup Guide


To enter setup mode:  
Locate the two prongs on the corner of the main board.
Use a coin to touch each prong and hold it.
Release the coin when the LED Display shows rELEASE P.b.
 
   
To exit setup mode:  
Use a coin to touch each prong and hold it.
Release the key when the LED Display shows rELEASE P.b.
 
   
How to read the display:  
<< Et Image >>  
Station 1 displays the current feature
Station 2 displays Ch (meaning channel). This refers to the station or bed number
Station 3 displays the station number for the current feature
Station 5 & 6 display the setting or reading for the current feature
 
   
Press the button on Station 1 to cycle through each feature
Press the button on Station 2 to move up to the next station number
Press the button on Station 3to move down to the previous station number
 
   
The following features are accessed in setup mode:  
 

ET as displayed by FST TimerElapsed Time

Elapsed Time tracks the total hours and minutes for each station.

 

Station 5 shows the the hours and Station 6 shows the minutes.

Press the button on Station 2 to view the elapsed time for the next station.

Press the button on station 1 for the next feature.

 
   
   

 


Home | FST Timers | SunEase Software | Sales
& Services
| Support | Downloads | Contact


Page last updated January 9, 2002
Copyright 1996-2002, F.S.T. Company, All Rights Reserved
SunEase is a registered trademark of F.S.T. Company. All products names trademarks
and registered trademarks are the property of their respective companies.